Black out shades12/16/2023 Rollers: 3 ¼” in diameter to prevent sagging of shades even 20′ wide.Shades must be mounted to the underside of a beam/ceiling or to the face of a beam/wall, and cannot be ‘end mounted.’ Installing within 3 miles of salt water is considered salty air and changes the warranty on metal parts, not the fabric or motors. Better to upgrade to the Citadel High Wind Zipper Track Shades. Subjecting them to maximum wind load on a regular basis will cause them to wear out faster. If used with a wind sensor and shade was raised because of wind, shade can automatically lower at a preset time as long as the wind was not blowing at that timeĪn outdoor shade should be retracted in windy conditions.If used with a wind sensor shade can be lowered after 15 minutes of reduced wind (requires a security camera to show position of shade).Create up to 40 scenes and schedules to automatically operate multiple shades Create scenes by grouping multiple channels together create schedules by setting one or more scenes on a timer.TaHoma’s performance is directly related to health and reliability of the WiFi network.Must be within range of 25-35ft from shade Somfy recommends at least one TaHoma™ interface per room or zone, and up to 10 gateways in one home to increase the range.Requires regular radio hand-held remote for initial programming and to set limit stops.Maintains motor/device settings even during a power failure.Compatible with most third-party systems such as Control4®, Crestron, Savant, Elan, RTI, URC, and Brilliant.Works with with Amazon Alexa, IFTTT, Phillips Hue, Samsung SmartThings, and Google Assistant.Compatible with IOS 11.0+ and Android 7.0+ Operate your shades with the free TaHoma™ North America App while home or away, or integrate with third-party systems.Turn your smartphone or tablet into a remote control for motorized shades with the Somfy TaHoma™ using WiFi (requires a security camera to know if shades are up or down).You can disconnect sun sensor and operate it with the remote, but you can’t disconnect the rain sensor as the shade will behave erratically searching for a signal from the disconnected rain sensor every 20 minutes.Passing clouds and shadows could raise and lower shade many times a day with rain sensor also lowering it for rain.Once rain is reduced to below your setting for 2 minutes with the sun shining on the sensor, the shade will be raised again.If sun sensor has raised the shade but rain exceeds your setting, the rain sensor will override the sun sensor and lower the shade to care of showers.Sun sensor raises shade when it senses enough light, or lower when senses not enough because of nightfall, clouds, shadows from trees, etc.Set rain sensor from condensation/fog to heavy rain snow will also activate it.These are solar powered so no need to plug in sensors.Requires Soliris hand- held remote to set sun sensor which can also be used to program limit stops (wall mounted remotes can’t do it).You may disconnect the sun sensor and operate it manually, but you can’t disconnect the wind sensor as the shade will search for a signal from a disconnected wind sensor every hour and behave erratically.Passing clouds could possibly raise and lower shade many times a day with the wind sensor also raising it for wind.Once wind is reduced to below your setting for 15 minutes with sun shining on the sensor, the shade will lower.If sun sensor has lowered shade but wind exceeds your setting the wind sensor will override the sun sensor and raise the shade. It will retract when light dims because of nightfall, clouds, shadows trees etc Shades will lower when wind higher than your setting is sensed for 2 minutes, or when enough light is sensed.Sensors plug into a grounded outlet, best to have one for each direction shades are facing as wind comes at them differently.Wind and Sun/Wind Sensors automatically retract shades between 6-31 mph.Must order Soliris hand-held remote to set sun sensor and program limit stops (not wall mounted).
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |